Foggy Windows and Failed Window Seals

Windows · 6 min read

You clean the window inside and out, and it is still cloudy. Maybe it clears up on a cold morning and fogs again when the sun hits it. That haze is trapped between the panes, and it means the seal on that piece of glass has failed.

The good news: the fix is often smaller than a whole new window.

How an Insulated Glass Unit Works

Most windows made in the last few decades use an insulated glass unit, two or three panes held apart by a spacer around the edge. The spacer is sealed to the glass and filled with a desiccant, a drying material that soaks up any moisture trapped during manufacturing. The space between the panes holds dry air or an insulating gas such as argon.

As long as the seal holds, the air inside stays dry and the glass stays clear.

Signs of a Failed Seal

  • A haze or fog you cannot wipe off from either side
  • Fog that comes and goes with sun and temperature
  • Water droplets or streaks inside the glass
  • A white film or mineral spotting between the panes
  • One pane looks different from the others on the same window

Why Seals Fail

Every day the gas between the panes expands in the sun and contracts at night. Every winter the glass faces a big difference between a warm room and a subzero outside. That constant pumping works the seal. Over enough years, it lets moist air in, the desiccant fills up, and the fog appears.

Other things speed it up: water sitting against the bottom edge of the glass, a sash that has twisted, direct afternoon sun, and simple age. It is usually the unit, not something you did.

Not Every Foggy Window Has a Failed Seal

Where the moisture sits tells you what is going on.

Where you see moistureWhat it usually meansWhat to do
Room side of the glassIndoor humidity meeting cold glassLower humidity, run fans, keep air moving over the glass
Outside of the glassNormal on efficient glass on cool morningsNothing, it burns off
Between the panesThe seal has failedReplace the sealed unit or the window

Is a Foggy Window a Problem?

It is not dangerous, and the window still keeps weather out. But three things change. The view is gone. Whatever gas fill the unit had has likely leaked out, so it insulates less than it did. And moisture cycling inside the unit can leave mineral deposits that etch the glass, so cleaning it out later rarely makes it look new.

For more on moisture you can wipe off, see our post on window condensation.

Your Options

From smallest to largest:

  1. Replace the glass only. If the frame and sash are sound, we measure the unit and order a new sealed unit to fit the existing sash. This is the most common fix.
  2. Replace the sash. Some windows are easier to fix with a complete new sash from the manufacturer, when it is still available.
  3. Replace the window. If the frame is rotted, several units are failing, or the window has other problems, full replacement is the better money.
  4. Wait. A fogged unit will not hurt the house. If you plan to replace the window soon anyway, living with it is a fair choice.

What About Defogging?

Some services drill small holes in the glass, dry the space, and seal the holes. That can clear the view for a while. It does not restore the original seal, and it does not put back any gas fill. We would rather replace the unit so it performs the way it was built to.

What a Glass-Only Replacement Involves

We take the sash or the glass stops apart, remove the failed unit, and measure its width, height, and overall thickness. The new unit is built to those dimensions, usually with Low-E and argon. Then it goes back in with new glazing tape or sealant, the stops are reset, and the sash goes back into the frame.

On many windows the only thing that changes is the glass. Your trim, paint, and siding stay as they are, and the window operates the same way it did before.

Get It Fixed

Our foggy window repair page explains how we replace failed units, and our glass repair page covers broken and cracked glass too. If more than a few windows are going, compare with window replacement before you decide.

Questions

Frequently Asked Questions

Not really. The moisture is sealed inside the unit. Cleaning the surfaces will not reach it, and drilling a unit yourself risks cracking it.

We measure the old unit’s size and overall thickness so the new one fits the sash. We can usually order Low-E and argon to match or improve on what you had.

A failed unit often shows its fog most when the outer pane is coldest. NOAA’s 1991-2020 normals put the average January low at 5.8F at the Superior station, so the outer glass here spends much of the winter very cold.

They use the same kind of edge seal, so yes, a triple-pane unit can fail too. The fix is the same: replace the sealed unit.

Our shop is at 7500 Tower Ave in Superior. Call (715) 685-0500, Monday through Friday, 7 to 4.

Get Started Today

Got A Foggy Window?

Tell us how many windows are fogged and where they are. We will tell you whether a glass-only fix makes sense and put the price in writing.