Why Your Shower Door Is Leaking

Problem Guide · 6 min read

First, Find Where The Water Gets Out

A puddle on the bathroom floor doesn’t tell you much by itself. Water travels along the curb, under trim, and across tile before it shows up. Spend ten minutes watching before you buy parts.

  1. Dry the door, the curb, and the floor outside the shower completely.
  2. Close the door and run the shower the way you normally use it, at your usual angle and pressure.
  3. With a flashlight, watch from outside the shower. Check the bottom of the door, the hinge side, the latch side, the corners where the curb meets the wall, and under any bottom track.
  4. Note where the first drop appears, not where the water ends up.
  5. If the door area stays dry but water shows up elsewhere, or there’s staining on a ceiling below, the problem may be the valve, the drain, or the shower pan. That’s a plumbing or tile question, not a glass one.

Common Causes, And How To Check Each

CauseWhere you’ll see waterQuick check
Worn or missing bottom sweepUnder the door, center or latch endLook for a torn, yellowed, or curled sweep, or one that no longer touches the curb
Hardened or split side sealsHinge or latch side, running down the edgeSeals should be flexible, not stiff or cracked
Clogged weep holes (framed doors)Water spilling over the bottom trackPour a cup of water in the track and see if it drains back into the tub
Door out of alignmentOne corner, usually the latch sideGap wider at top than bottom, or the door drifts open
Curb sloped the wrong wayAlong the whole outside of the curbSet a marble on the curb; it should roll toward the drain
Showerhead aimed at a gapHinge or latch side during useTurn the head toward the back wall and test again
Failed caulk at the wall or curbCorners where glass or metal meets tileLook for gaps, lifting, or dark lines in the caulk

Framed Doors: Start With The Track

Most framed and sliding doors sit in a bottom track with small weep holes on the inside edge. Water that gets into the track is supposed to drain back into the tub or shower through those holes. When they clog with soap scum and minerals, or someone caulks them shut, the track fills and spills over the outside.

Clean the weep holes with a toothpick or a small brush and flush the track. Caulk belongs on the outside of the bottom track where it meets the tub or curb, not along the inside, where it traps water.

Frameless Doors: Gaps By Design

A frameless door can’t touch the fixed panel or the wall when it swings, so it’s built with small, deliberate clearances at the hinge side, the latch side, and the bottom. Clear vinyl or polycarbonate seals and sweeps close those gaps. They wear out, harden, split, and occasionally just fall off. Replacement seals are sized to the thickness of the glass, so it helps to know whether your door is 3/8 or 1/2 inch glass.

Two installation details matter as much as the seals. The top of the curb should pitch toward the drain so water runs back into the shower instead of out under the sweep. And the door should hang plumb. Hinges can creep over time, and a door that sags even slightly opens a wedge-shaped gap at the latch corner.

What You Can Fix Yourself

  • Clean weep holes and flush the bottom track on a framed door
  • Replace a snap-on bottom sweep or side seal that matches your glass thickness
  • Re-aim the showerhead so it doesn’t spray straight at a door gap
  • Cut out and replace failed caulk on the outside joints
  • Squeegee the glass and wipe the curb after showers so minerals don’t stiffen new seals

When To Call A Pro

Some leaks are a sign the door needs adjustment or parts you can’t easily source. Call if the glass touches glass or metal when it swings, if the door sags or won’t stay closed, if the curb slopes outward, or if leaking continues after new seals and fresh caulk. Our shower door repair page covers the common fixes, and if you’re weighing a new enclosure, start with our frameless shower door page.

Questions

Frequently Asked Questions

Seals wear, harden, and shrink with age and hard water, and hinges can creep out of adjustment. A door that sealed well for years often just needs new sweeps and a small hinge adjustment.

Generally, no. Caulk the outside joints where the frame meets the tub, curb, and wall. Caulk along the inside of a bottom track can block the weep holes and push water out instead of letting it drain back.

In many cases, yes. Seals and sweeps are sized to the glass thickness and door style. If a matching part isn’t available for an older door, we’ll tell you what the options are.

They’re built with small gaps a framed door doesn’t have, so they depend on good seals and a properly sloped curb. Installed right, they keep water where it belongs. Our frameless vs framed comparison covers the tradeoffs.

Yes. The federal safety standard for architectural glazing, 16 CFR 1201, covers shower doors and enclosures and bathtub doors, which is why that glass is tempered.

It can. Water that gets under flooring or into a subfloor does damage long before it shows. If you see soft flooring, loose tile outside the shower, or a stain on the ceiling below, deal with it promptly.

Get Started Today

Shower Door Still Leaking?

Send us a photo of the door and where the water shows up. We’ll tell you what it needs and put the price in writing.