Is It Really A Draft?
Not every cold spot by a window is a leak. Glass on a January night is much colder than the room. Air next to it cools, gets heavier, and slides down the pane to the floor, pulling warmer room air in behind it. That loop feels exactly like a draft on your ankles, even when the window is sealed tight.
The difference matters because the fixes are different. A true air leak needs sealing. A cold-glass draft needs warmer glass: a storm window, a better sealed unit, or a new window. The test below tells you which one you have.
How To Find The Leak
The U.S. Department of Energy’s Energy Saver guide recommends a simple smoke test on a windy day. Here’s the version we’d use at home:
- Pick a windy day. Close every window and exterior door.
- Turn on the bath fans and the range hood. Pulling air out of the house makes leaks draw harder and easier to spot.
- Hold a lit incense stick close to the edges of each sash, the meeting rail where the two sashes overlap, the lock, the sill, and the inside trim.
- Watch the smoke. If it streams sideways or gets pulled toward the window, you’ve found a leak. If it rises straight up but the area still feels cold, the glass is the issue.
- Look for daylight around the sash, and try to rattle it. A sash that moves in its frame is likely leaking air.
- Mark each leak with painter’s tape so you remember where they are.
Weatherstripping, Sash, Frame, Or Glass?
| Where the cold comes in | Likely cause | Typical fix |
|---|---|---|
| Along the edges of the sash | Worn, flattened, or missing weatherstripping | New weatherstripping sized to the gap |
| At the meeting rail and lock | Sash lock not pulling the rails together, or a warped sash | Adjust or replace the lock; repair the sash |
| Around the inside trim | Gap between the window frame and the wall | Caulk the trim, and insulate the gap if accessible |
| Old double-hung sides | Open sash-weight pockets and pulley holes | Seal or insulate the pockets, or add a storm |
| No moving air, just cold | Single-pane glass or a failed sealed unit | Storm window, new sealed unit, or new window |
| Sash won’t close fully | Swelling, rot, or a frame out of square | Sash repair or window replacement |
Quick Fixes Before The Snow Flies
The rule of thumb: caulk for joints that don’t move, like trim and frames, and weatherstripping for parts that do, like sashes and doors. DOE’s Energy Saver guide estimates that sealing uncontrolled air leaks can save 10 to 20% on heating and cooling bills.
- V-strip or foam weatherstripping on the sash edges and meeting rail
- Removable rope caulk on windows you won’t open until spring
- Shrink-film plastic kits on the interior trim of the worst windows
- Insulated cellular shades, closed at night and opened by day to let the sun in
- Fresh caulk where interior trim has pulled away from the wall
Storm Windows: The Underrated Fix
Plenty of homes in Superior and Duluth still have original wood windows. Many of those sashes are old-growth wood worth keeping, and a good storm window turns them into a far better assembly. DOE’s Energy Saver guide says low-e storm windows, interior or exterior, can save 10 to 30% on heating and cooling costs depending on the window already in place, and that they should have weatherstripping at all movable joints.
A storm window also cuts the wind that drives leaks and adds a pocket of still air in front of the glass. Our storm windows page covers the styles and how they’re fitted.
When Replacement Makes Sense
Weatherstripping and storms go a long way, but some windows are past it. Consider replacement windows when the sills or sash bottoms are soft, when several sealed units have fogged, when sashes won’t operate or lock, or when the frame is out of square and nothing seals. Today’s energy-efficient windows pair insulated Low-E glass with tight weatherstripping built in, which addresses the air leak and the cold glass at the same time. If the drafty window is also icing up, read why ice forms on the inside of windows.
